Cleaning Tips

 For wallpaper, spray Goklein on and wipe off with a dry towel. Use same solution on wall panels and wipe clean. For greasy buildup, use a non-abrasive scrounge pad. 

 For spot cleaning, spray on GOKLEIN and let stand for 30 seconds. Rinse with clear water and wipe dry with towel. When using a carpet  shampoo machine, vacuum area to be cleaned first lifting all loose particles. Using one (1) cup of GOKLEIN to every five (5) gallons of water, c lean carpet concentrating on heavily soiled areas. Let dry and vacuum again. To clean without a machine, follow same procedures as above using a soft bristle brush to loosen soil, rinse and wipe clean with towel. 

 NOTE: Test fabric for colorfastness or bleeding before cleaning.
For spot cleaning, use 20:1 spraying on stained area and rub in circular motion with a dry towel. For stubborn stains, use 15:1 and let stand for 3 to 5 minutes. You may use a nylon brush to assist you, rubbing in a circular motion. Rinse and wipe dry with towel. 

 Use 2:1 for set-in stains; test before using. For pre-washing, spray on spots or ring-around-the-collar using 20:1. Let stand for 30 to 60 seconds, and then rub with a nylon brush or towel. Add to your regular wash load. You may also add 1/2 cup of GOKLEIN in your wash load.  For fresh ink spots on clothing, place a towel underneath the spot and using the nozzle of the sprayer, rub in a circular motion over the stain after having sprayed directly into the towel. For old stains, spray the stained area directly and let stand for five (5) minutes. Add to your regular wash load. 

 Using a pin or needle, punch holes in the gum, glue or candle wax and spray on using a 20:1 dilution. Let stand for 60 seconds and rub away the residue using a nylon brush.

Using a 20:1 dilution of GOKLEIN before painting makes an excellent bonder. GOKLEIN can also be used as a thinner by adding a 10:1 dilution per one gallon of paint. 

 For general cleaning, use a 20:1 dilution of GOKLEIN to clean floors, then rinse.   For tough stains a nonabrasive scrounge pad may be used.   As a wax stripper, use an GOKLEIN dilution of 2:1 along with an abrasive pad to remove wax buildup. Rinse.
(CAUTION: Do not use on no-wax floor!)

All the above may be cleaned with a 20:1 dilution of GOKLEIN . Spray on and use a non-abrasive scrounges pad to assist then wipe clean and rinse. For stubborn stains allow GOKLEIN to stand for 1 to 2 minutes before wiping clean. Rinse.
NOTE: For telephone equipment, computers, etc., do not spray directly into equipment. Dampen cloth and clean dirty areas.